#LASERDRW 3 FROM INKSKAPE PDF#
#LASERDRW 3 FROM INKSKAPE SOFTWARE#

If the answer is no, go back to check it. The recommended speed for our polywood is around 8mm/s.ДЈ.3 Before hit вЂstartingвЂ™, you need to activate our machine.ДЎ) Open air vent and cooling air (coming soon) Дў) Plug in Laser cutter, water pump and exhaust fan (the socket is under the table) ДЈ) Connect your laptop to laser machine by blue USB cable ДҐ) Load your material (like polywood) and close orange Protective Cover Д¦) Adjust the вЂCurrent RegulationвЂ™ to match your material (for example, plywood, the current is marked as below) Д©) Hold the вЂTest SwitchвЂ™ for one second to check if the laser cutter works.

You can change the style according to your design. lyz file, and you will see the picture like following.ДЈ.2 Find the вЂEngraveвЂ™ and click it, then a small window will pop up as below. DXF file into Inkscape.ДЈ.1 Double click your. For example, I draw my pattern in Autodesk and save the design as.

#LASERDRW 3 FROM INKSKAPE SOFTWARE#

Or you can use other software for design, and import the design into Inkscape. zip(Laser Draw LYZ) as the picture shows. * Note: The software and its installation instruction will be attached(Window only).Дў.1 We use Inkscape to design the pattern, shown as following.Дў) Use BLUE lines to indicate vector engraving ДЈ) Use BLACK to indicate raster engraving (this can be shapes, paths or images)Дў.2 After you finish your design, save it as. Hardware: USB keyпј€shown as following pictureпј‰, Plywood Software: Inkscape, Inkscape extension, LaserDRW

There are several materials you need to prepare before you use the machine. **Worning: For safety, it is better to have a training before use it.**

#LASERDRW 3 FROM INKSKAPE PDF#

Note: The PDF version of tutorial is attached here. By the support of included software, LaserDRW, this machine can work well with multiple graphic formats including lyz/bmp/jpg. It employs an USB port and thus can be connected to your laptop or desktop. This laser engraver is equipped with one 40W water cooling laser tube, high precise stepping motors, high quality control board. We have a new machine in our lab! It is a laser cutter, which can be employed in both carving and cutting works.

Laserdrw 3 from inkskape